42
Cleaning and replacing the dust filters
Cleaning the dust filters
Clean the dust filters after every 1000 hours of use. If they are note cleaned
periodically, they can become clogged with dust, preventing proper ventilation.
This can cause overheating and damage the projector.
Follow these steps:
1 Turn the projector off. Wait for the Power LED to stop flashing then
unplug the power cord.
2 Allow the projector at least 30 mins to cool down.
3 Unplug the corner (Illustration #1)
4 Pull out the dust filter (Illustration #2)
5 To clean the dust filters, use a small vacuum cleaner designed for
computers and other office equipment.
6 If the dirt is difficult to remove or the filter is broken, please contact your
local dealer or service center to obtain a new filter.
1
2
LAMP
TEM
P
MENU
ENTER
SOURCE
BACK
To Next Page
Loading...
