Acer PD100 - Page 23

17 Chapter 2
No Step Procedure Photo
3 Key in Serial
Number
1. Key in the Serial Number
into the Barcode blank
space.
2. In "White Source Select",
make a check in "VGA"
and "DVI".
3. Check the COM Port is
"COM 1".
4. Click "Program".
4 Change Cable
to Analog
"Please change the Cable
to Analog" message is
shown on the screen, then
click "OK".
Note: "RUN" message will
appear on the screen.
5 Change Cable
to Digital
"Please change the Cable
to Digital" message is
shown on the screen, then
click "OK".
Note: "RUN" message will
appear on the screen.
6 Finished When the EDID program is
completed, the message,
"OK", will appear on the
screen.
2
1
3
4