6. Firmware Upgrade Process
ACER S230HL
48
Go to contents page
6.3 ISP Programming Procedures:
S1. Launch the utility ISP Tool.
S2. Press [Connect] button for verifying the ISP connection whether if be established.
S3. Setup communication type, select [Config] option and change ‘Port Type’ from type list of LPT1, LPT2, and
USB per system setting. For example, the USB is selected then press [Auto Detect] button to check its hardware
connection. The message [OK] stands for connection successful.
S4. Press ‘Read’ button for loading the binary file.
S5. Select [Auto] button for entering download menu, then press [Run] button for updating firmware. Once you see
the message of ‘Pass’ shown on the window, it means firmware update is finished
6.4 How to Check firmware version?
S1. Turn off the monitor, press “Power” and “e” button at the same time for turning on the monitor.
S2. Press “Menu” button again to enter factory mode, and you will see the firmware version on the screen.
Note: Please pay attention: Don’t change any parameter which is measured by precise machine before shipping out.
To Next Page
Loading...
