Setting
Source Lock
Selecting "On" enables the function and when switching
input signals, you need to press "SOURCE" on the control
panel or remote control, or the direct source key on the
remote control. When this function is disabled, the projector
will detect your source automatically.
Auto Screen
Default is "Off", the down/up move of electronic screen will
be related with power on/off of the projector.
HDMI CEC
Selecting "On" allows synchronized power ON/OFF operation
between the projector and a CEC-compatible device
connected to the HDMI port of the projector.
This function is only available for the internal HDMI
port.
LAN Control
LAN
The default value is "Off". Choose "On" to enable the LAN
connection.
LAN IP/Mask
Identify IP and Mask address.
LAN Reset
Press "ENTER" after choosing "Yes" to return all items on the
Tools page to the default settings.
PIP
PIP
• Choose "On" to see two screens at the same time.
• Choose "Off" to disable the function.
PIP Source
Press to choose the secondary video source: D-sub,
HDMI 1 or HDMI 2 signal.
PIP Location
Choose the PIP secondary signal location on the display
screen.
PIP Size
Choose the PIP secondary signal size on the display screen.
PBP
PBP
• Choose "On" to see two screens at the same time.
• Choose "Off" to disable the function.
PBP Source
Press to choose the secondary video source: D-sub,
HDMI 1 or HDMI 2 signal.
Information Displays current status of this projector.
Reset
Press "ENTER" after choosing "Yes" to return the display
parameters on Setting menu to the factory default settings.
To Next Page
Loading...
