INSTRUCTION MANUAL FOR DISHWASHERS
Page 2 of 12
Chap 1 PREFACE
Failure to follow the instructions provided in the attached documentation may jeopardize
safety of the appliance and immediately cancel the warranty.
The warnings contained in this manual provide important information regarding safety
during the various installation, operation and maintenance stages.
• Carefully store all documentation near the appliance; give it to the technicians and operators who
will be using it.
It is the operator’s duty to read, understand and learn this manual before
starting any operation on the machine. The appli
ance is intended for the professional washing
of dishes for dining facilities.
Therefore, installation, use and maintenance must always be
performed by trained personnel who follow the manufacturer’s instructions. Do not leave within
the reach of children.
The choice of materials, construction in conformity with EC safety directives
and complete testing ensure the quality of this machine.
The manufacturer declines all responsibility for damage to property or injuries to persons
deriving from failure to comply with the instructions given or from improper use of the
Chap 2 INSTALLATION
Proper installation is essential in order for the machine to operate properly. Some of the data needed for
machine installation can be found on the data plate placed on the right side
of the machine and in
duplicate on the cover of this manual.
Only qualified, authorised technicians must install the machine.
2.1 Unpacking
Check that the packing is in perfect condition and write down any damage found
After you have removed the packing, make sure the appliance is intact.
If the machine is damaged,
immediately notify the dealer by fax or by registered letter with advice of receipt and the haulage
contractor that transported it. If the damage is such as to jeopardize machine safety,
do not install and/or
use it until a qualified technician services it.
The packing components (plastic bags, foam polystyrene, nails, etc. ...) must not be left
within the reach of children and pets as they may be dangerous.
2.2 Positioning
•
Check that there are no objects and materials in the installation area
that can be damaged by steam that may exit the machine during
operation, or at least that they are sufficiently protected.
•
In order to ensure stability, install and balance the machine on its four
feet.
•
Different installation solutions must be agreed upon and approved by
the manufacturer.
To Next Page
Loading...
