Acom 1200S - Page 48

User's Manual | ACOM 1200S | 1.8-54 MHz Linear Power Amplifier
Page
48
of
60
| S e c t i o n MAINTENANCE
August 2021
If, after Primary Mains Fuses replacement, the device does not operate normally, we
recommend repair, performed only by a trained service technician.
Contact your ACOM dealer for assistance (see Section 1.2 Owner Assistance).
Besides the primary fuses, there are internal fuses inside the amplifier.
WARNING
Do not replace internal fuses located inside the amplifier.
Blown internal fuses can be a symptom of a more serious problem, which should be
resolved beforehand. A fault of this type will not occur under normal operating
circumstances.
Replacing internal fuses is a complex and potentially dangerous operation.
For this reason, we recommend this work be carried out only by a trained service
technician.
Contact your ACOM dealer for assistance (see Section 1.2 Owner Assistance).
Unauthorized replacement of inside fuses infringes the warranty conditions!
Besides several specific national standards, the principal fuses standard applied
worldwide is IEC 60127.