HEAT PUMP
AIR / WATER
WITH REGULATION
ACOND® THERM
OPERATING MANUAL
Software version 140.1 and 140.2
In short:
To turn the heat pump on / off:
• If the symbol is on the display and the room temperature is not
displayed, the heat pump is switched off.
• Press and hold the rotary button on the room unit for about 7s. The heat pump is
switched on, the display shows the room temperature.
• When the heat pump is switched on, pressing and holding the rotary button (7s)
switches the heat pump off.
To set the room temperature:
• Press the rotary button.
• The desired indoor temperature flashes on the display.
• Turn the button to the right to increase the desired room temperature by 0.5 °C, turn
the button to the left to decrease it.
• Press the rotary button again and the display will display the room temperature
again.
• For more information, see chapter 3.1.5 on page 15.
To determine the outdoor temperature:
• Turn the button to the right and the outdoor temperature will be displayed for 5s.
To determine the temperature of service water (TUV):
• Turn the button to the left and the water temperature (if fitted) will be displayed for
5s.
To Next Page
General