Table 6 Heat pump parameters to be entered by the spatial unit
After pressing the rotary wheel, the parameter value is displayed, the symbol and
the corresponding symbol marking the active parameter flash. By turning the wheel it is
possible to change the parameter value, short press to save the changed value, the symbol
stops flashing and the system returns to the parameter selection. Long press will
end parameter entry, the Basic view will be restored (see 3.1.3 Basic view).
3.2 Control via web interface
3.2.1 Heat pump internet connection
The connection of the heat pump to the Internet will be made by a service technician during the
installation of the heat pump or later via the Acond service telephone line (+420 601 373 073).
Users access a web server with a heat pump database when logging in. Connection speed
varies depending on the number of simultaneously logged in users.
The heat pump is assigned a fixed IP address during installation at the
customer's premises, therefore, when replacing the router or modem in the
home network, make sure to maintain the original address space. Any service
call due to reconfiguration of the IP address of the heat pump will be charged
according to the valid Acond price list.
3.2.2 Login to the system
3.2.2.1 Via website www.acond.cz:
Enter the address in the address bar of your web browser (Google Chrome, Firefox, Internet
Explorer, etc.):
www.acond.cz
Confirm with ENTER to display the Acond website (see Figure 1).
To Next Page
Loading...