Chapter3 Installation / 25
1. AT Keyboard port
This connection is for a standard keyboard using an AT size (Large
DIN) plug . This connector will not allow standard at PS/2 key-
board plugs (mini DIN).
2. PS/2 Mouse port
This system will direct IRQ12 to PS/2 mouse.
3. Serial Port COM 1 and COM 2 port
The two serial ports can be used for pointing devices or other
serial devices. See "Onboard Serial Port" in chipset Feature Setup
of the BIOS SOFTWARE.
4. Parallel Printer port
You can enable the parallel port and choose the IRQ through "
Onboard Parallel Port" in Chipset. Feature Setup of the BIOS
SOFTWARE.
5. Universal Serial BUS Ports 1 & 2
Two USB ports are available for connecting USB devices.
6. Floppy drive connector
This connector supports the provided floppy drive ribbon cable.
After connecting the single end to the board, connect the two
plus on the other end to the floppy drives.
To Next Page
Loading...
