ACTi A88 - A88, A94, A96

www.acti.com
Hardware Manual
10
A88, A94, A96
Item
Description
1
Power Input
Connects to a DC 12V adapter to power up the camera if using a
non-Power over Ethernet connection.
2
Ethernet Port
Connects to a network using an Ethernet cable.
3
Memory Card Slot
Insert a memory card (not included) into the slot for local
recording purposes. See How to Insert the Memory Card on
page 24 for more information.
NOTE: Supports microSDHC and microSDXC cards
4
Reset Button
Restores the factory default settings of the camera.
To reset the camera, do the following:
1. While the camera power is disconnected, press and hold the
Reset Button then power up the camera.
2. The Green LED starts to blink, continue holding down the
Reset Button until the Green LED goes off and the Yellow
LED lights on.