ACV Comfort E 160 - Checks before Starting up; Starting up Procedure

CHECKS BEFORE STARTING UP
• Check that the safety valves (DHW and primary) are correctly installed and that the outlets are
connected to the sewer.
• Check that the DHW tank and the primary circuit are filled with water.
• Check that the air has been correctly bled from both circuits.
• Check that the tank’s upper air bleed valve is tight.
• Check that the water side and heat source side pipes are correctly connected and not leaking.
STARTING UP
To put the installation into service, refer to the heating boiler manual.
en
24
Comfort E : A1002860 - 661Y1600 • D
EN
NL
ES
IT
DE
PL
RU
FR
STARTING UP
STARTING UP PROCEDURE
If the tank is used as an electric DHW tank only :
1. Put the electric plug into the mains socket
2. Set the Summer / Winter switch on the summer (
) position and check that the indicator
is on.
3. Adjust the required temperature using the control thermostat.
If the tank is used within a heating installation:
To put the installation into service, refer to the heating boiler manual.
1. Put the Summer / Winter switch on the winter (
) position and check that the indicator is
o.
2. Adjust the required temperature using the control thermostat.