Appendix C: Using the Adaptec RAID Configuration Utility ● 101
● Storage Enclosure Processor (SEP) managed devices—The connection is determined by an
active backplane. Box0 (enclosure 0) is connected to slot0 (disk drive slot 0 in the
enclosure). For more information, see Backplane Connections
on page 79.
● Expanders—The connections is determined by an expander. Exp0 (expander 0) is
connected to phy0 (phy 0 within a connector). For more information, see SAS Expander
Connections
on page 80.
Note: Devices other than disk drives (CDROM, tape drives, etc...) are listed in order after your
system disk drives.
To Next Page
Loading...
