Appendix C: Using the Adaptec RAID Configuration Utility ● 97
All supported SSDs are displayed.
3 Using the arrow keys, select an SSD from the list.
4 Press Ins to add the SSD to the MaxIQ pool.
5 To remove an SSD from the pool, press the right arrow to switch windows, use the arrow
keys to select an SSD, then press Del.
6 Press Enter to save your changes and return to the main menu.
Using SerialSelect to Modify Controller Settings
The SerialSelect utility is a tool for modifying the settings of your controller and the disk drives
connected to it.
Opening SerialSelect
To open Ser i a l Select, start the ARC utility (see page 92), select SerialSelect, then press Enter.
Follow the on-screen instructions to modify the settings of your controller and connected disk
drives as required.
Applying Changes and Exiting
1 To exi t Ser i a l Select, press Esc until you are prompted to exit.
If you modified any settings, you are prompted to save the changes before you exit.
2 Select Ye s to exit, then press any key to restart your computer.
Any changes you made take effect after the computer restarts.
Modifying Your Controller’s Configuration
Note: Default controller settings are suitable for most computers. Adaptec recommends that
you do not change the default setting.
To modify your controller’s basic settings, select Controller Configuration from the main
SerialSelect menu.
To modify your controller’s power management settings, select Advanced Configuration.
To modify your controller’s PHY settings, select PHY Configuration.
Some options may not be available for your controller.
To Next Page
Loading...
