Chapter 10: Solving Problems ● 74
6 Disconnect all cables from the controller, then attach a shorting jumper to the Mode 0
flash connector. (To locate the Mode 0 flash connector on your Adaptec RAID controller,
see the figures in
About Your RAID Controller
on page 17.)
7 Reconnect the power cord, power on your computer, then boot to the floppy disk
containing the AFU.exe file (see Step 3).
8 At the prompt, type
a:\afu update /c x
where
x
is the controller number.
9 Insert the other floppy disks when prompted.
10 When the flash is complete, power off your computer, disconnect the power cord, then
remove the jumper.
11 Close the computer cabinet, reconnect the power cord, then power on your computer.
The controller should boot correctly.
To Next Page
Loading...
