BETA BRITE Programming Manual
Introduction: Operating a BetaBrite® sign 5
To program a sign with a Remote Control:
• Stand at least 5 feet and no more than 30 feet from the sign.
• Make sure nothing reflective is in front of the sign. (Light from
the sign’s display that is reflected back can interfere with the
Remote Control.)
• If nearby fluorescent lights interfere with the Remote Control,
you may have to relocate either the lights or the sign.
30
o
30
o
30
o
30
o
If a sign is this far from the floor...
...then hold a Remote Control this far
away:
10 feet from 10 to 30 feet
15 feet from 19 to 30 feet
20 feet from 25 to 30 feet
Figure 1: Using a Remote Control with a sign
Side view Front view
To Next Page
Loading...
Need help?
General
