BETA BRITE Programming Manual
10 Basic sign operation: Setting a sign’s password
Setting a sign’s password
You can set a personal password to protect your messages and
graphics from tampering by others.
If you forget the password,see“What to do when you forget a sign’s
password” on page 11.
Step When you do this... You see this...
1 Press PROGRAM.
2 Press BACK until SET PASSWORD appears.
3 Press ADV.
4 Press Y to set a password.
5
Type a 6-character password. (Only asterisks will
appear on the sign as you type.)
Re-type the password when prompted.
CORRECT will appear if you entered the same
password.
If you failed to type the same password, ERROR will
appear, and you’ll have to start over from Step 1.
6 Press RUN twice.
7
Press Y to password protect the sign.
NOTE:If you select N, then a password will not be
needed when you press PROGRAM.
PROG TEXT A
SET PASSWORD
SET PASSWORD? Y/N
ENTER 6 CHAR’S
******
RE-ENTER THE 6
THEN
******
THEN
CORRECT
THEN
PROG TEXT A
PASSWORD RUN? Y/N
SECURE
The sign will return to normal operation.
Now, whenever you press PROGRAM, you’ll have
to type the password you just entered.
To Next Page
Loading...
Need help?
General
