To Next Page

To Previous Page

Home Station ADSL ADB P.DG A4001N

Hardware Installation 15

POWERING UP THE HOME

STATION ADSL

To power up the Home Station ADSL:

1. Plug the power adapter into the power adapter port located on the rear of the

Home Station ADSL

2. Plug the power adapter into a standard electrical wall socket

3. Press the Power button located on the rear panel of the Home Station ADSL

4. Wait for the power LED to turn steady green

In case of power input failure, the Home Station ADSL will automatically restart and

begin to operate once the input power is restored.

If the Home Station ADSL is properly configured, it will take about 90 seconds to es-

tablish a connection with the ADSL service provider after powering up.

During this time the ADSL LED will flash. After the ADSL connection has been estab-

lished, the ADSL LED indicator will stay on.

CONNECTING THE HOME

STATION ADSL

The first step to install the Home Station ADSL is to physically connect it to the tele-

phone socket and then to connect it to a computer with Ethernet connection. After

these steps, in case a compatible 3G Key will be available, the 3G key connection

and configuration will be needed.

To connect the phone cable:

1. Connect one end of the phone cable into the T-connector adapter which is in-

serted into the wall plug.

2. Connect the other end of the phone cable into the DSL port on the rear of the

Home Station ADSL

ADB P.DG A4001N User Manual

Questions and Answers: