14
Host selection
The Hosts button on the menu bar provides the quickest and most efficient way
to switch between host computers. This is because the button is close at hand,
but also because the screen calibration details for each host are reused when
this method of switching is used.
Note: The Hosts button is displayed only when the switching details for two or
more computers have been declared within the configuration section by the
admin user.
To select a host
1 Click the Hosts button to display a list of
computers.
2 Click the required computer name to view and
control it.
See Host configuration for details about
programming new hosts into the Digital iPEPS (‘admin’
user status required).
Configure
This option is displayed only when you are logged on as the ‘admin’ user. When
selected it provides access to a wide range of Digital iPEPS settings.
See Appendix 4 for more details.
To Next Page
Loading...
Need help?
General
