40
Serial port configuration
This page allows you to configure the baud rate of the Digital iPEPS serial port
that is used to control power switch devices. A full range of standard baud rates
are available.
To get here
1 Using VNC viewer or a browser, log on as the ‘admin’ user.
2 Click the ‘Configure’ button in the top right corner.
3 Click the ‘Serial port Configuration’ option.
Baud Rate
Determines the communication speed of the OPTIONS port when the above
setting is configured to ‘Power Control’. The other communication settings are
fixed as: No parity, 8 bit word, 1 stop bit.
To Next Page
Loading...
Need help?
General
