33
Unit configuration
This page provides access to a selection of both basic and advanced settings for
the Digital iPEPS. Many of the settings displayed here are also accessible through
the on-screen menu.
Unit Name
The name entered here will be displayed on the local menus and the remote
VNC viewer/browser windows.
New Connections Private
Allows you to determine whether new local or VNC connections should be set
up as private (when ticked) or as shared (when unticked).
Menu Bar Toggle Hot Key
Determines the function key that can be used to display/hide the menu bar
within the VNC screen.
Encryption
Three options are available: Always on, prefer off, prefer on. The one to choose
depends on the specific details of your installation. The use of encryption
imposes a slight performance overhead of roughly 10% but is highly secure
against third party intrusion.
Number of simultaneous VNC Users
Allows you to restrict the number of concurrent VNC sessions. The maximum
number (and the default setting) is 4.
VNC Viewer Hot Key Sequence
When using the VNC Viewer, you can use key press combinations to select host
computers and also to display the host selection menu. This option allows you
to choose which keys should be used to form the hotkeys that will precede a
switching command. The default setting is CTRL + ALT, so as an example when
you press the CTRL ALT and 2 keys, the viewer will change to the host with
“Hotkey Host Number” 2 - see Host configuration.
EDID Configuration
Advanced Unit Configuration
Hardware Version
Indicates the version of the electronic circuitry within the Digital iPEPS unit.
Firmware Version
Indicates the version of the internal software within the Digital iPEPS flash
memory. This may be updated using the flash upgrade procedure.
Host Keyboard Layout
Use the arrow buttons to match the keyboard layout expected by the host
system.
Admin (Change) Password
Click this button to enter/edit the password that will be used to gain
administrator access to the Digital iPEPS.
To get here
1 Using VNC viewer or a browser, log on as the ‘admin’ user.
2 Click the ‘Configure’ button in the top right corner.
3 Click the ‘Unit Configuration’ option.
To Next Page
Loading...
Need help?
General
