13
relevant parts, then use the dry clothe to dry them.
4. You can pull the Water drain pipe of the water tank indicating “H” in above illustration to drain out
the cleaned water in the water tank, then next to clean inner ic e-storing bin, till all of inner parts are
cleanly, then drain out all of the cleaned water from the water drain port located at unit back
indicating “8”in above illustration. And must to install back the water drain pipe of the water tank
and the cap of the unit wat
er drain port, otherwise, the unit will not make the ice normally. And
suggest that you should discard the ice-cube ma de by the first ice making cycle after
cleaning. Note: Please see the section “Water Draina ge” in this manual to dra in out the cleaned
water.
5. The outside of the ice maker should be cleaned regularly with a mild de tergent solution and warm
water.
6. Dry the interior and exterior with a clean soft cloth.
OPERATION YOUR UNIT
WATER CONNECTION FOR YOUR ICE MAKER
Important: Be sure to use the new hose-sets supplied with the appliance to
connect to water mains and that old hose-sets should not be reused.
1、Connect the water supplying hose to the unit
Step 1:First remove the tape on the water inlet port for water supply
(indicated in the following illustration “B”) located at unit back, then use your
other hand’s finger to press the out circle。
Step 2: Insert the one end of the w hite water hose into the water inlet port,
and push inward completely, and install back the clipper, then water hose
connection is completed.
STEP 1: Remove the
tape first
Water inlet port on
the unit back
STEP 2: Insert the
water hose
Then install
back the clipper
White water
hose(accessory)
First insert the
water hose inward
completely
Remove the
clipper first
Unit Back View
To Next Page
