ADJ DMX Operator - Chase Editing Operations; Delete a Step; Delete a Complete Chase; Delete All Chases

ADJ Products, LLC - www.adj.com - DMX Operator User Manual Page 14
DMX Operator Editing
DELETE A STEP:
1. Press the PROGRAM BUTTON (6) for three seconds to activate Program Mode.
The LCD DISPLAY (3) will indicate Program Mode by displaying a continuous flashing light
next to “PROG”.
2. Select the CHASE BUTTON 1 TO 6 (5) that contains the step you would like to delete.
3. Press and release the TAP SYNC/DISPLAY BUTTON (11).
4. After selecting the TAP SYNC/DISPLAY BUTTON (11) use the UP and DOWN BUTTONS to
manually scroll to the step you wish to delete.
5. When you have reached the step you wish to delete, press and release the
AUTO/DEL BUTTON (8).
DELETE A COMPLETE CHASE:
1. Press the PROGRAM BUTTON (6) for three seconds to activate Program Mode.
The LCD DISPLAY (3) will indicate Program Mode by displaying a continuous flashing light
next to “PROG”.
2. Press and hold down the AUTO/DEL BUTTON (8).
3. While holding down the AUTO/DEL BUTTON (8) press the CHASE BUTTON 1 TO 6 that you
want to delete, twice
. The chase should be deleted.
DELETE ALL CHASES:
This function will allow you to clear all chase memory (delete all chases).
1. Press and hold down the AUTO/DEL (8) & BANK DOWN BUTTONS (4).
2. While holding down the AUTO/DEL (8) & BANK DOWN BUTTONS (4) disconnect the
power.
3. Holding down the AUTO/DEL (8) & BANK DOWN BUTTONS (4) reconnect the power hold
for 3 seconds LED’s blink all chase memory should be erased.