ADJ DMX Operator - Programming and Editing Chases; Programming Chases; Insert a Step

ADJ Products, LLC - www.adj.com - DMX Operator User Manual Page 13
DMX Operator Programming Chases/ Editing
PROGRAMMING CHASES:
Note: You must program sceNes before You caN program chases.
1. Press the PROGRAM BUTTON (6) for three seconds to activate Program Mode.
The LCD DISPLAY (3) will indicate Program Mode by displaying a continuous fast blinking
dot next to “PROG”.
2. Select any CHASE BUTTON 1 TO 6 (5) to program.
3. Select a desired SCENE BUTTON (2) from any bank that has been previously recorded.
4. Press the MIDI/REC BUTTON (7) and all LED’s will blink 3 times
5. Repeat steps 3 & 4 as many times as you want. You may store up to 240 steps into one chase.
6. To exit the Program Mode, press the PROGRAM BUTTON (6) for three seconds. The LCD
DISPLAY (3) will indicate Blackout Mode by displaying a continuous fast blinking dot next
to “Blackout”. You may now playback the Recorded Chase. (See pages 15-16)
EDITING CHASES
INSERT A STEP:
1. Press the PROGRAM BUTTON (6) for three seconds to activate Program Mode.
The LCD DISPLAY (3) will indicate Program Mode by displaying a continuous flashing light
next to “PROG”.
2. Select the CHASE BUTTON 1 TO 6 (5) you wish to add a step to.
3. Press and release the TAP SYNC/DISPLAY BUTTON (11), and the LCD DISPLAY will now
show the step you are now in.
4. After selecting the TAP SYNC/DISPLAY BUTTON (11) use the UP and DOWN BUTTONS to
manually scroll to the STEP you wish to insert a step after.
5. Press MIDI/REC BUTTON (7) the LCD DISPLAY will show one step number higher.
6. Press the Scene Button you want to insert.
6. Press MIDI/REC BUTTON (7) again to insert new step.
7. Press and release the TAP SYNC/DISPLAY BUTTON (11) to return to normal operation.