The heater hood and side panels are fixed by screws for transportation and need to be
removed, and the filter door connection checked.
1. Open the filter door by unscrewing the thumb screw as marked (A) below, it does not
require to be removed, just enough so the door can lift and swing open.
2. Once the door is open, you will see a connector towards the bottom of the door
as in the image below (centre) Make sure this is fully connected.
3. While the door is open, remove the screw marked (B) that is securing the side panel.
Once the screw is removed, gently lift the side panel (
C)
and slide forward from behind
the door.
4. Proceed to remove the side panel from the opposite side, by removing screw (B).
5. Once both sides are removed, remove the two screws that are holding the hood cover
in place. There is one screw either side located as below.
1.
UNBOXING/SET UP
Please read before connecting to power and operation
A
B
B
C
C
page 4
Continued
To Next Page
Loading...
