7-1. Function setting
Before starting test run, check carefully the following points :
(1) Be sure to connect the power supply to L1, L2, L3 (input terminals)
and the motor to W.V.U. (output terminals). (Wrong connections will
damage the inverter.)
(2) Check that the input power supply coincide with input voltage and
input phase of the inverter.
(3) Check the signal lines for correct wiring.
(4) Be sure to ground an earth terminal for personnel safety.
(5) Check that other terminals other than earth terminal are not
grounded.
(6) Check that the inverter is mounted on the wall on non-flammable
material.
(7) For operation start and stop, use and FWD / REV
terminals. Never use input power supply to switch ON/OFF.
STOP
31
To Next Page
Loading...
