ADT Garda Response PM30

To Next Page

To Previous Page

Adding Code

Step 1

On the Main Panel press Open Padlock and enter your master code to exit

the screen saver

Step 2

Press

Step 3

The display will show: ‘User Settings’

Step 4

Press OK

Step 5

Type in your Code

Step 6

The display will show: ‘Set Zone Bypass’

Step 7

Press Next until you nd ‘User Codes’

Step 8

Press OK

Step 9

The display will show the ‘User 01 Code █‘,

Step 10

Press (Next) until you nd a user slot without a square (i.e. ‘User 02

Code‘)

Step 11

Press OK

Step 12

The display will show: ‘User ## : 0000’,

Step 13

Type in a new code and press OK

Step 14

The display will show: ‘User 02 Code █‘,

Step 15

You can add further codes by repeating process from Step 10.

Step 16

To exit press the (locked padlock) and press OK

ADT Garda Response PM30 - Adding Code