Advanced Instruments Anoxomat Mark II CTS User Manual

Chapter 1 Installation and setup
14
Anoxomat Mark II CTS User’s guide
Register users
To limit access to the Anoxomat, user IDs can be
established to identify the technician before every recipe
is run.
1. On the Registration screen, press Register Users to
display the Register Users screen.
2. In the “Add user” section of the screen (Fig. 1.15), enter
the user’s full name as you want it to appear on the
printout and in the database.
3. Enter the user code that will be required for the user
to operate the Anoxomat. The user code will not
appear anywhere, but will need to be entered each
time a recipe is started.
4. Press Submit to add the name and code to the list of
registered users (Fig. 1.16).
5. Repeat steps 2–4 for each registered user.
6. To delete a registered user, select the entry from the
Registered Users list and press Remove.
7. Press Close to save your settings and exit to the
Registration screen. When you have finished
configuring Jar Setup and Register Users, press
Close to exit the Registration screen and return to
the Setup screen.
Fig. 1.15: Add user
Fig. 1.16: Registered User
As long as even a single user has been registered to use
the Anoxomat, the Anoxomat cannot be operated
without entering a correct user code.

Advanced Instruments Anoxomat Mark II CTS Specifications

General

Brand	Advanced Instruments
Model	Anoxomat Mark II CTS
Category	Medical Equipment
Language	English