The Advanced
®
Osmometer Model 3320 Service Manual
11
Hazardous Material
Cautions
• WARNING: Handle all biohazardous
materials according to established good
laboratory practices and follow your insti-
tution’s exposure control plan. Persons
handling human blood and body fluid
samples must be trained in blood-borne
hazards and observe universal precautions.
Universal precautions is an approach to
infection control, where all human blood
and body fluids are treated as if known to
be infectious. Use personal protective
equipment such as gloves, gowns, etc., to
prevent exposure. Store biohazardous
materials in regulated waste containers and
dispose of these materials in a safe and
acceptable manner that is in compliance
with all country, state and local require-
ments.
• If a biohazardous material is spilled on or
inside the equipment, decontaminate the
equipment using a 1% bleach solution, or
as outlined by those policies and proce-
dures established within your institution.
• To avoid injury or fire hazard, do not oper-
ate this product in an explosive atmos-
phere.
Regulatory Notices
• This product has been designed and manu-
factured in accordance with U.S.,
Canadian, and European regulatory
requirements as outlined below. Modifica-
tions made to this product that are not
expressly approved in writing by the man-
ufacturer will void the user’s authority to
operate this product, previously issued fac-
tory approvals, and the user’s rights under
the warranty.
• The distributor or dealer may have applied
additional local, national, or international
approvals to this product. Consult the dis-
tributor or dealer for more information and
documentation.
• Connections to this product must be made
with shielded cables. Use of non-shielded
cables may violate RFI/EMI limits.
Symbol Conventions
This symbol indicates conformity to
relevant European directives.
This symbol indicates the product
was tested to conform to relevant
Canadian and U.S. safety standards
by Intertek Testing Services NA,
Inc. The ETL mark is approved in
the United States as a Nationally
Recognized Testing Lab (NRTL) by
OSHA, and in Canada by the
Standards Council of Canada.
In Vitro Diagnostic Medical Device
complying with EU Directive
98/79/EC.
This symbol, depending upon its
location, indicates the assembly,
component, and/or product are free
of lead. In respect to its inclusion on
a circuit component or assembly, the
following must be adhered to when
servicing. Failure to do so may
result in defects caused by dissimilar
metals.
1. Do not repair or modify using a
lead-containing solder.
2. Do not repair or modify using any
soldering tools that have been in
contact with lead-containing sol-
ders.
3. Do not repair or modify with any
lead-free solder other than that
specified by the manufacturer or
as indicated by the symbology of
standard IPC-1066.
4. Do not repair or modify using any
soldering tools that have been in
contact with any other incompati-
ble lead-free solders.
5. Contact factory service for further
information.
To Next Page
Loading...
Need help?
General