The number in this symbol indicates
the type of lead-free solder used in the
assembly of printed circuit boards, per
standard IPC-1066. Repair or modifi-
cation must be performed using the
same or compatible type lead-free sol-
der and matching tools. Failure to do
so may result in defects caused by dis-
similar metals.
Contact factory service for further information.
FCC Requirements
• WARNING: Changes or modifications to
this unit not expressly approved by
Advanced Instruments could void the user’s
authority to operate the equipment.
• This equipment has been tested and found
to comply with the limits for a Class A dig-
ital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful inter-
ference in a commercial environment. This
equipment generates, uses, and can radiate
radio frequency energy and, if not installed
and used in accordance with the instruc-
tions, may cause harmful interference to
radio communications. Operation of this
equipment in a residential area is likely to
cause harmful interference, in which case
the user will be required to correct the
interference at his own expense.
The Advanced
®
Osmometer Model 3320 Service Manual
12
U.S. Safety This product has been listed by
ETL testing laboratories as being in
compliance with the requirements
of UL 61010-1, Second Edition,
“Safety Requirements for Electrical
Equipment for Measurement,
Control and Laboratory Use; Part
1: General Requirements". The
"US" in the lower right of the ETL
mark demonstrates this listing.
Canadian Safety This product has been listed by
ETL testing laboratories as being in
compliance with the requirements
of CAN/CSA C22.2 No. 61010-1,
"Second Edition, “Safety Require-
ments for Electrical Equipment for
Measurement, Control and Labora-
tory Use; Part 1: General Require-
ments". The "C" in the lower left of
the ETL mark demonstrates this
listing.
EC Declaration of: This product meets the intent of
Conformity - Low Directive 2006/95/EC, the Low
Voltage Voltage Directive. Compliance was
demonstrated using the following
standards as listed in the Official
Journal of the European Communi-
ties: Consult the Declaration of
Conformance certificate shipped
with the product (if required) for
the latest update.
· EN 61010-1, "Safety Require-
ments for Electrical Equipment
for Measurement, Control and
Laboratory Use - Part 1:
General Requirements".
· IEC 61010-2-101, “Safety
Requirements for Electrical
Equipment for Measurement,
Control, and Laboratory Use;
Part 2-101: Particular Require-
ments for In Vitro Diagnostic
(IVD) Medical Equipment, First
Edition”.
EC Declaration of This product meets the intent of
Conformity - EMC
Directive 2004/108/EC for Electro-
magnetic Compatibility. Compli-
ance was demonstrated using the
following standards, as listed in the
Official Journal of the European
Communities: Consult the Declara-
tion of Conformance certificate
shipped with the product (if
required) for the latest update.
• EN 61326-1, Group 1, Class B,
"Electrical Equipment for
Measurement, Control, and
Laboratory Use".
Regulatory
approval type Description
EXAMPLES
ONLY
To Next Page
Loading...
Need help?
General