Advantech Adam 4000 Series User Manual

4-170 ADAM 4000 Series User's Manual
Command Set
4080, 4080D
$AA2
Name Configuration Status
Description The command requests the return of the configuration data
from the counter/frequency module at address AA.
Syntax $AA2(cr)
$ is a delimiter character.
AA (range 00-FF) represents the 2-character hexadecimal
address of the analog input module that you want to interro-
gate.
2 is the Configuration Status command.
(cr) is the terminating character, carriage return (0Dh)
Response !AATTCCFF (cr) if the command is valid.
?AA(cr)if an invalid operation was entered
There is no response if the module detects a syntax error or
communication error, or if the specified address does not exist.
! is a delimiter character indicating a valid command was
received
? is a delimiter character indicating the command was invalid
AA (range 00-FF) represents the 2-character hexadecimal
address of counter/frequency module that you want to interro-
gate.
TT (50h or 51h) represents the type code. 50h means that using
module as counter. 51h means using module as frequency
measurement module.
CC represents the baud rate code.
FF is a hexadecimal number that equals the 8-bit parameter
representing the checksum status and frequency gate time. The
layout of the 8-bit parameter is shown in figure 4-5. bits not
used are set to 0.
(cr) is the terminating character, carriage return (0Dh)
(Also see the %AANNTTCCFF configuration command)

Advantech Adam 4000 Series Specifications

General

Brand	Advantech
Model	Adam 4000 Series
Category	Control Unit
Language	English