Advantech Adam 4000 Series - Page 99

Chapter 4 Command Set 4-15
Chapter 4
ADAM-4017 Command Table
Command Syntax Command Name Command Description Page No.
%AANNTTCCFF Configuration Set the address, input range, baud
rate, data format, checksum status
and/or integration time for the
specified analog input module
444
#AAN Read Analog Input
from Channel N
Return the input value from channels
number N of the specified analog
input module
454
#AA Read Analog Input from
all Channels
Return the input values from all
channels of the specified analog input
module
4-52
$AA0 Span Calibration Calibrate the analog input module to
correct for gain errors
457
$AA1 Offset Calibration Calibrate the analog input module to
correct for offset errors
458
$AA2 Configuration Status Return the configuration parameters
for the specified analog input module
448
$AA5VV Enable/disable Channels
for Multiplexing
Enables/disables multiplexing
simultaneously for seperate channels
of the specified input module
455
$AA6 Read Channel Status Ask the specified input module to
return the status of all eight channels
456
$AAF Read Version Return the firmware version code
from the specified analog input
module
450
$AAM Read Module Name Return the module name from the
specified analog input module
451