265 ADAM-4000 Series User Manual
Chapter 8 Calibration
4. Execute the Offset Calibration command. This is also done through the ADAM
utility software. (Please see “Offset Calibration” option in the Calibration sub-
menu of the ADAM utility software).
Figure 8.2 Zero Calibration
5. Execute the Span Calibration command. This can be done through the ADAM
utility software. (Please see “Span Calibration” option in the Calibration sub-
menu of the ADAM utility software).
Figure 8.3 Span Calibration
To Next Page
Loading...