2.7.8 Suspend Type
The
choices are “Stop
Grant” and
“PwrOn Suspend”.
2.7.10 Suspend Mode
Please refer to 2.7.5
2.7.11 HDD Power Down
Select “1-15 mins” to enable HDD Power Down mode between 1 to 15 mins. Select
“Disabled” to disable HDD Power Down function.
2.7.12 Soft-Off by PWR-BTTN
If you
choose “Instant-Off”, then
pushing the ATX
soft power switch
but- ton once will
switch the system
to
“system off” power mode. You can choose “Delay 4 sec”. If you
do, then
pushing the button
for
more
than 4 seconds
will turn
off
the
system, whereas
pushing the button momentarily
(for less
than 4 seconds)
will switch the system
to “suspend” mode.
2.7.13 Wake-Up by PCI card
The choices are “Enabled” and “Disabled”.
2.7.14 PowerOn by Ring
Select “Enabled”
to power
on the system from a soft off state by an input signal on the
serial Ring Indicator (RI) line. The choices are
“Enabled” and “Disabled”.
2.7.15 USB KB Wake-Up From S3
When “Enabled”, enter any key to wake up the system from S3 state. The choices are
“Enabled” and “Disabled”.
2.7.16 Resume by Alarm
When “Enabled”, set the date and time at which the RTC (real-time clock) alarm
awakens the system from suspend mode. The choices are “Enabled” and “Disabled”.
2.7.17
Primary IDE 0 (1) and Secondary
IDE 0 (1)
When Enabled, the
system will resume
from suspend mode if
Primary
IDE 0 (1)
or Secondary IDE 0 (1)
becomes active.
The choices are
“Enabled” and “Disabled”.
2.7.18
FDD, COM, LPT PORT
When Enabled, the
system will resume
from suspend mode if
the FDD, interface,
COM
port, or
LPT port is
active. The
choices are
“Enabled” and “Disabled”.
2.7.19
PCI PIRQ [A-D]#
When Enabled, the
system resumes
from suspend mode if
an
interrupt occurs.
The choices are “Enabled”
and
“Disabled.
2-18 Chapter 2: BIOS setup
To Next Page
Loading...
Need help?
General
