2.8 PnP/PCI Configurations
Figure
2.10: PnP/PCI configurations
screen
2.8.1 Init Display First
This item allows you to choose the first display interface to initiate while booting.
The choice is “PCI Slot” or “Onboard”.
2.8.2 Reset Configuration Data
The
default is
“
Disabled”. Select
Enabled to reset Extended System Configuration
Data (ESCD) if you
have installed a new add-on card,
and system configuration is
in
such a
state that
the
OS cannot boot.
2.8.3 Resources Controlled By
The commands here are “Auto(ESCD)”
or “Manual”. Choosing
“Manual” requires
you
to choose resources
from the
following sub-menu.
“Auto(ESCD)” automatically configures all
of
the boot
and Plug and
Play devices,
but you
must be using Windows 95
or above.
2.8.4 PCI/VGA
Palette Snoop
This
is set to “Disabled” by default.
2.8.5 Maximum Payload Size
This
allows you
to set
the maximum TLP payload size
for
PCI Express devices.
The options
are
[128
bytes], [256 bytes], [512 bytes],
[1024 bytes], [2048
bytes],
and [4096 bytes].
AIMB-763 2-19
To Next Page
Loading...
