19
Channel Selection
3
Use Direct Channel Selector (0-9 and --- )
Use CH+ or CH- button
Before you select a channel, please select TV or Cable input signal. Please
see the Tuning section to set the TV/Cable input.
When you select TV, only channels received on antenna can be selected;
When you select Cable, channels received on cable can be selected.
Press one of the 0-9 digit keys and wait for 2 seconds.
Input the channel using the digit keys. Be sure to enter the
channel within 2 seconds.
Press "---" to display "1--".
Press two digit keys to input the remaining two digits of the
channel. For example, to select channel 124, press "---", press 2,
then press 4.
Press CH+, the channel number increases;
Press CH-, the channel number decreases.
Press this button to switch between the current channel and the
previous channel.
Press the SCAN button, the TV set
scans all channels one by one.
Every channel will be displayed for 2
seconds.
This function helps you to quickly
browse all active programs. Press any
button can stop Channel Scanning.
To select one-digit channel:
To select two-digit channel:
To select three-digit channel:
Previous channel button
1
2
Scanning channels
2
3
1
5
6
4
8
9
7
CH
CH
VOL
VOL
MUTE
FREEZE
ZOOM
DEMO
DSP
FAVO
VCD/HIFI/DVD
SET
TVVCR Cable/SAT
SCAN
PIC
SOUND
STEREO
MENU
AV
SLP
3
2
Direct
channel
selector
SCAN
Channel Scanning
(Available in "Cable" mode only)
To Next Page
Loading...
General