g
41
0 Pull the emptied grounds container
out until it is under the coffee dis-
penser, to collect the descaling solu-
tion (Fig. 42).
The "Empty grounds container" indica-
tor (Fig. 3, j) comes on and remains
illuminated for as long as the grounds
container is pulled out.
0 Press the "Descale" key (Fig. 3, e) for
3 seconds. The indicator changes from
flashing to constantly on. The program
is ready. The descaling process must
not be interrupted.
3
You must first descale the hot-water/
steam nozzle, before the automatic
process can begin.
0 Place a cup or jug with a capacity of at
least 200 ml under the hot-water noz-
zle. Turn the Selection dial for steam
and hot water (Fig. 1, D) to the
position (Fig. 43). Keep the selection
dial opened until the pump switches
off and descaling solution stops run-
ning out of the nozzle.
0 Turn the Selection dial for steam and
hot water (Fig. 1, D) back to the
position (Fig. 43). The automatic des-
caling process now starts through the
coffee-making unit.
3
During the descaling process, the "Des-
cale" key (Fig. 3, e) indicator is con-
stantly illuminated.
Preparing the coffee machine for
phase 2
Phase 1 of the descaling process fin-
ishes after around 36 minutes. This is
signalled by the "Fill water tank" indi-
cator (Fig. 3, k) and the "Empty
grounds container" indicator (Fig. 3, j)
flashing. The indicator flashes
(Fig. 44).
0 Rinse the water tank out and fill with a
maximum of 1 litre fresh water.
0 Empty the grounds container and push
it just far enough back into the coffee
machine to catch the water which
drains out of the coffee dispenser
(Fig. 42).
Phase 2: flushing
0 Place a cup or jug with a capacity of at
least 200 ml under the hot-water noz-
zle.
0 Turn the Selection dial for steam and
hot water (Fig. 1, D) to the posi-
tion (Fig. 43). Keep the selection dial
opened until the pump switches off
and flushing water stops running out
of the nozzle.
0 Turn the Selection dial for steam and
hot water (Fig. 1, D) back to the
position (Fig. 43). The automatic fresh-
water flushing process now starts
through the coffee-making unit. It
takes approximately 5 minutes.
The flushing process – and with it the
complete descaling program – is fin-
ished when the indicator is on and
the indicator flashes.
0 Empty the coffee grounds container.
0 Thoroughly rinse the water tank and
fill with fresh water.
The coffee machine is now ready for
use.
3
After running the descaling program,
you are advised to throw away the first
cup of coffee from the machine.
13.7 Ordering Accessories
To ensure years of satisfaction with
your coffee machine and prevent
faults arising, it is very important to
regularly clean and descale the coffee
machine. The original cleaning tablets
and descalant are obtainable direct
from us.
If you live in Germany, please call our
Order Hotline
Tel. 0 18 01-20 30 90.
To Next Page
Loading...
Need help?
General
