CAUTION:
Always transport/ship the unit in the original packing to avoid dam-
ages. Retain the original packing materials for this purpose. Recycle
useless packing material in accordance with your countries regula-
tions.
NOTE:
Damages due to transport must be reported to the supplier immedi-
ately.
Assembly
1. Fold out the stand at the rear of the unit.
2. Place the unit on a stable, level and at surface. Maintain a dis-
tance of a minimum of 10 cm from walls and other objects.
3. Connect the unit to an outlet installed according to regulations.
4. Remove protective cover from device / TFT Screen if applicable.
Operation
Insert Batteries into the Remote
Control
WARNING:
Leaking battery acid may cause a health hazard. Remove batteries from
the remote control when depleted or the unit is not in use for an extended
period of time. Clean up any leakage with a cloth immediately. In the event
of skin contact, rinse the aected area immediately. In case of ingestion
consult a physician immediately. In the event of eye contact, rinse eyes and
consult a physician immediately.
CAUTION:
Dierent battery types or new and used batteries must not be used
together. Dissimilar batteries feature dissimilar qualities. Do not use
old and new batteries together. Combined use of old and new bat-
teries may shorten the life span of the new batteries and may cause
leakage of the old batteries. Upon disposal, adhere to the recycle and
environmental regulations of your respective country. Never throw
batteries into open re.
NOTE:
The life span of enclosed batteries may be reduced due to storage.
1. Open and remove the lid from the battery compartment.
2. Place two batteries Type AAA/R03 (1. 5 V) in correct polarity (+ and
-) into the battery compartment. Always start with the negative
pole (-).
3. Replace and close the battery compartment lid.
NOTE:
The signals of the remote control are transmitted to the device by
infrared light. Ensure that the device is not exposed to direct sunlight.
This could otherwise render the signal transmittal from the remote
control to the device impossible.
To Next Page
