AEG Protect A Series - Installation Site; Front Panel

18
4.2 Installation Site
Protect A is designed to be installed in a protected environment.
When installing the unit, pay attention to such factors as sufficient
ventilation and suitable ambient conditions.
Protect A is air/fan-cooled. Do not obstruct the air vents!
The UPS should preferably be operated at room temperature
(between 15 °C and 25 °C).
Install the UPS in a room that is dry, relatively dust-free and free of
chemical vapours.
Make sure that no magnetic storage media are stored and/or
operated close to Protect A.
Check the nameplate to make sure the voltage and frequency data
correspond to the values applicable to your loads.
4.3 Front Panel
① Power ON/OFF
② LCD Indications
③ USB charger 5V 2A max
1
2
3
3
1
2