AEG PROTECT RCS - Connecting the Load; System Start-Up Procedures; Preliminary Checks Before Start-Up

- 13 / 50 - BN 09 2671/01/01
4.4 CONNECTING THE LOAD
Connect the load (+) to the load (+) terminal of the equipment.
Connect the load (-) to the load (-) terminal of the equipment.
5 START-UP (REFER TO THE PRODUCT
DRAWING)
5.1 PRELIMINARY CHECKS
All circuit-opening devices must be in the "open" position.
Check that the mains line protective device rating has the appropriate rating (see section 4.1).
Check that the mains voltage and frequency are compatible with the equipment (see equipment nameplate).
Check that the mains, battery and load connections are tight.
Check the polarities and that the battery cells are correctly connected in series.