Main menu
Configure
Monitoring
Hit any key
Command
Measurements
Alarm list
History list
Set language
Set date and time
Setup
Left ke
menu
Middle ke
menu
Right key menu
Set high rate
floatin
Set commissioning
floatin
Manual adjustment
Battery test
Clear history
Reset AH meter
Adjust contrast
Available only in charger mode
Available only in power supply mode
Output voltage, battery current, load voltage, AC voltage, battery temperature, ambient
temperature, battery charge, charger timer, date and time
Password *
if activated
Alarm text, “RESET” alarm
Events and alarms text with date, time, and set point
System setup
Calibrate setup
Alarm setup
Password *
if
iv
Password *
Password *
“Supervisor”
assword
“User”
w
r
Nominal settings, highrate options,
battery selection, password setting…
Activate high rate or floating charge
Activate commissioning or floating charge
Activate or deactivate battery test
Clear history entries
- Menu overview -
Reset at 100% battery charge level
+/- LCD contrast adjust
*
English or your local language
Enter hour, minutes, month, day and year
Voltage and current power supply adjustment
Access usually granted with "Supervisor" password
only (access rights are factory configurable)
Default menu
5 minutes inactivity
see § 6.5.1
see
6.5.2
see § 6.1
see § 6.2
see § 6.5
see
6.7
see § 6.6
see
6.5.3
see
6.7.1
see § 6.6.1
see
6.6.2
see
see
6.6.
see
6.6.6
see § 6.6.7
see § 0
see
6.7.2
see
6.7.3
* “User” or “supervisor” password
Note: According to your equipment configuration, some menus may be inactivated.
Calibrate voltage, temperature,
ground fault…
Low/high voltage, current,
s
are in
uts…
Access granted with "Supervisor"
password only (access rights are not
configurable)
Access usually granted with "User" (partly)
and "Supervisor" passwords (access rights
are factory configurable)
“Factory”
rotected level
- 17 / 50 - BN 09 2671/01/01