BN 09 2671/01/01 - 26 / 50 -
6.6.5 Battery capacity test Function (OPTION)
The Battery Test feature can be used to test the battery performance. The test can be initiated manually or
automatically.
Three programmable parameters define the battery test:
Discharge Current
End Voltage
Tolerance percentage.
Warning:
Contact the nearest agent of your equipment for details of the above settings.
Wrong settings can cause mis-interpreted battery performance or loss of DC power.
6.6.5.1 How to Activate the Battery Test
Before activating this test, make sure you are familiar with the Battery Test Operation as further described in
paragraph 0 BATTERY CAPACITY TEST.
Follow the instructions below.
Starting from the main menu, select ‘Cmnd’.
Select ‘Next’ until the following menu is displayed.
Press ‘Enter’.
If protected by a password enter the password here.
With the right pointing arrow '' the digit position can be selected and with the arrow up '' an alphanumeric
character between 0 and 9 or between A and Z can be set. When all four characters are set, press ‘Enter’.
If the password is correct, the display switches to the Battery Test on/off selection. If the password is incorrect, a
message ‘WRONG PASSWORD’ is displayed for two seconds and the menu jumps one position back in the menu
tree.
Activate or de-activate the Battery Test by selecting 'On' or 'Off'.
The display will show if the battery test is on or off.
FLOATING CHARGE
Monit Confg Cmnd
BATTERY TEST
Next Enter Exit
Password: 1111
nter
Battery test
On Off Exit
Correct password
WRONG PASSWORD
To Next Page
Loading...
