AERMEC RePuro 650 - Page 36

36
IREPPY - 1404 - 4238051_01
AVM

For oor mounted units.
Feet in plasc material to screw onto the
base. When selecng consider the space
needed for the condensate discharge.
SSR
Support brackets with anti-vibration
items
For oor mounted units.
Support bracket in painted galvanised
steel to screw onto the base. When select-
ing consider the space needed for the con-
densate discharge.
The kit contains 4 adhesive an-vibraon
items to sck onto the bracket.
FF7170 - FF7350 - FF7650
Filter with efficiency class F7
When the quality of the external air re-
quires a higher efficiency replace the
standard G4 filter with the accessory filter
with efficiency class F7.
KSAE

KSAE is a kit consisng of 1 external air
temperature sensor with plasc box for
wall mounng.
The KSAE sensor replaces the standard
sensor internal to the unit and permits
measuring the actual external air tempera-
ture, and not be aected by the air ducng
to the RePuro unit.
The KSAE sensor is an accessory that has
to be connected to the electronic board,
so all precauons shown for the electronic
board must be followed.
Use shielded cables.
Maximum connecon length 10m.
175
VCH
Three way valve
For plenum PLS and PLSM with water coil
(W).
Complete with connection tube and fix-
ings between valve and heat exchanger
coil.
The valve is of the on-off type and is 230V
single phase powered.
Warning:
To avid condensation the tubing must be
suitably insulated (neoprene polyure-
thane, polypropylene), of 6-10mm thick-
ness.
Also available is the condensate tray
accessory BC10 and BC20.