AERMEC VENICE - Programming Modes

18 23/05 – 4840212_00
PROGRAMMING MODES
Switch to the standard display view and press to enter programming mode.
Procedure
Push:
to access parameters with a password;
and to navigate and set parameters;
to change the parameter value and save the change;
(3 seconds) or ESC to return to the standard display view.
1 Switch to standard display view
2 Press
: password request appears (PSd)
3 Press
: the rst digit of the password ashes;
set the value and press again
. The second
digit now ashes; repeat the entry for each digit
to complete the required password.
4 Press
If the password is correct, the rst cate-
gory of parameters appears: PLt (=system)
5 Press
: the rst parameter appears: U002
(Pump 1 manual control)
6 Press
: value ashes; press / to
change the value; press again
to conrm.
7 Press
/ to view other parameters
8 Press
: for 3 seconds or, alternatively, at pa-
rameter level select ESC and press
to return
to the parameter categories
1
2 3
5 64
7
8