Aerogen USB Controller - Setup Procedures

Aerogen
®
6
Set Up
Read and study all instructions before using the Aerogen USB Controller.
Perform a functional test of the Aerogen nebulizer prior to use as described
in the Functional Test section of this manual (see page 23).
Connect the Aerogen Solo or Aerogen
Pro nebulizer by firmly pushing into
the T-piece.
Connect the Aerogen USB Controller
to the nebulizer as shown.
Insert the nebulizer and the T-piece*
in the breathing circuit.
* Adult T-Piece shown here. For full
instruction on T-piece location see
page 14 (T-piece Accessories).
1
2
3