AFL FlexScan FS200 OTDR Quick Reference Guide

4
While in the SmartAuto OTDR Settings Menu:
• Touch the desired setting eld/tab (e.g.
1
Test Type) to display a
sub-menu (where applicable).
• Touch
A
to navigate to next/previous screen.
• Touch
B
to return to the previous menu.
• Touch Use Defaults
C
(if displayed) to reset settings to defaults.
• Touch ‘Press to start’
D
to initiate testing.
SmartAuto OTDR Settings Summary
1. Test Type: Limited to Characterize in FS200-50B/100.
Select Characterize or FleXpress
™
Fast Test in FS200-60/300/304
when Network Type = Point-to-Point.
2. Pass/Fail Rule: Indicates selected LinkMap event pass/fail rules.
Touch to select ITU G.671, TIA-568.3-D or User. Touch and hold to
view/edit pass/fail event thresholds.
3. Network Type: Limited to Point-to-Point in FS200-50B/100 models.
Select Point-to-Point or FTTH PON in FS200-60/300/304 models. If PON selected, congure split ratio
settings to match expected network splitter conguration.
4. Fiber Type: Touch to select G.65x or User ber type. Touch and hold to view/edit associated Group Index of
Refraction (GIR) and Backscatter Coefcient (BC) settings.
5. Launch Cord: Touch to congure length of Launch cable, if present.
6. Tail Cord: Touch to congure length of Receive cable, if present.
7. Launch Quality Check: Enable to check OTDR connection to launch cord or jumper cable at start of test.
1
2
3
4
5
6
7
OTDR Modes: SmartAuto
™
with LinkMap
®
Display Summary
7
5 6
A
B
D
2
3
4
C
1

AFL FlexScan FS200 OTDR Specifications

General

Brand	AFL
Model	FlexScan FS200 OTDR
Category	Test Equipment
Language	English