18
Read the instructions before installing or using this
appliance.
WARNING: This appliance shall be installed in
accordance with the regulations in force and only
used in a well ventilated space. Read the instructions
before installing or using this appliance.
• Prior to installation, ensure that the local distribution
conditions (nature of the gas and gas pressure) and the
adjustment of the appliance are compatible.
• The adjustment conditions for this appliance are stated
on the data plate.
• The data plate is situated in the centre vent slot near the
base of the front plate.
• This appliance is not connected to a combustion
products evacuation device. It shall be installed and
connected in accordance with current installation
regulations. Particular attention shall be given to the
relevant requirements regarding ventilation (B.S. 5440
Part 2).
• It should be in accordance also with any relevant
requirements of the Gas Region and Local Authority.
• In your own interest, and that of safety to comply
with the law, all gas appliances must be installed by a
competent person. Failure to install appliances correctly
could lead to prosecution.
• On completion, test the gas installation for tightness.
WARNING: THIS APPLIANCE MUST BE EARTHED.
• The appliance is designed for the voltage stated on the
data plate.
• The appliance is supplied with and installed adjacent to
the left-hand side of R7/eR7 AGA cookers.
• Installation of the R7/eR7 Module must, therefore, be in
conjunction with the build instructions of the ‘parent’
AGA.
• Reference must be made to the above Installation
instructions for the ‘parent’ AGA especially regarding
pre-site inspection, not only for both cookers but to
consider any pipework that may pass at the rear of the
Module. i.e. flue duct from a Fan Flue AGA.
• The appliance has been designed to accommodate
pipework passing at the rear.
• THE MAIN AGA COOKER IS DELIVERED EX-WORKS,
FULLY ASSEMBLED.
• FINAL INSTALLATION IS UNDERTAKEN ON SITE, BY
AN AUTHORISED AGA ENGINEER.
• The AGA Module is supplied from the manufacturers in
a fully assembled condition.
8. Installation introduction
To Next Page
Loading...
