23
10. Installation Sequence & Procedure
The cooker must be installed by a qualied electrician, in
accordance with all relevant British Standards/Codes of
Practice (in particular BS 7671), or with the relevant national
and local regulations.
Having ensured all space requirements and regulations have
been satised for the combined arrangement (AGA R7/eR7 &
Module), the build and installation is to proceed as follows:-
It is essential that the base or hearth on which both
cooker and module stands should be level and capable of
supporting the total weight of both units.
• AGA eR7 = 370 kgs.
• AGA R7 = 444 kgs.
• Hotcupboard = 110 kgs.
• Module = 129 kgs.
1. Unpack and remove the Module from the pallet.
2. Check that the rear extension piece is secured to the left
hand side panel.
3. Undo 2 screws from front location brackets and remove
the bracket assembly. Now slide the Module o its
plinth and set to one side Fig. 10.1.
4. The Module plinth can now be levelled and tted up
to the main appliance. Position the Module plinth
alongside the AGA R7/eR7 leaving no gap between the
two plinths. (See Fig. 10.2).
5. When tting the Module against hotcupboard there
should be a gap of 16.5mm which is achieved by using
the spacers provided (See Fig. 10.3).
6. Check with a spirit level that the plinth is correct and
using a straight edge check that both plinths are aligned
along the front face (using either front or rear plinth
adjustment screw to alter alignment, if necessary).
7. Also check height dierential between the Module
plinth and AGA R7/eR7 plinth is correct: 11 mm. If
necessary, use the adjusting studs in each corner to
level the plinth. In extreme instances, shims may be
used underneath the plinths (See Fig. 10.2 or Fig. 10.4).
8. Attach Module plinth to the AGA R7/eR7 plinth using 2x
M6 screws and washers provided (See Fig. 10.5 or Fig.
10.6). Slide front jointing bracket into place over two
adjacent magnets, locking the two appliances together.
To Next Page
Loading...
