12
SERVICING WARNING
Disconnect from electricity before servicing. Check appliance is safe when you have finished.
Servicing Notes
Disconnect from electricity supply before commencing servicing, particularly before removing any of the
following: control panel, side panels, ceramic hob, or any of the electrical components or cover boxes. Before
electrical reconnection check that the appliance is electrically safe.
1. To change oven light bulb.
Replacement bulb must be 15w 125-130v lamp, FOR OVENS, heat resistant to 300°C (570°F).
Turn off the power at the circuit breaker
Make sure the oven is cool. Open the oven door and remove the oven racks.
Unscrew the bulb cover by turning counter clockwise. It
may be very stiff .
Taking care to protect your fi ngers in case the bulb
should shatter, unscrew the old bulb.
Screw in the new bulb, screw back the bulb cover. Turn
on the circuit breaker and check that the bulb now
lights.
2 How to Move the Range for Servicing
Follow these procedures to remove appliance for servicing:
Turn off the power at the circuit breaker
The range is very heavy. Take great care. We recommend two people maneuver the range. Ensure that the fl oor covering is
fi rmly attached, or removed to prevent it being disturbed when moving the range around. You will need the leveling tool.
There are two leveling rollers at the back and also two screw down leveling feet at the front.
Open the broiler door and right hand oven door so
that you can get a good grip on the bottom of the
control panel as you move the oven.
To Next Page
Loading...
Need help?
General
