13
SERVICING WARNING
Disconnect from electricity before servicing. Check appliance is safe when you have finished.
Do not move the range by pulling the door handles
or knobs. Lift the front slightly and slide the range
forward to disengage from the anti-tip bracket.
Move the range a bit at a time, checking behind it to
make sure the electric cord is not caught. Make sure
the electricity cable has suffi cient slack to move the
range forward as you go along
Disconnect electrical supply to appliance and unplug
the electrical supply cord.
Reverse procedure to reinstall.
If your range is removed for any reason, make sure the anti-tip device is re-engaged properly when the range is
replaced. Failure to take this precaution could result in tipping of the range and cause injury.
Replaceing the Range
Reverse procedure to reinstall the range.
Reconnect the power supply
Make sure the anti-tip device is re-engaged properly when the range is replaced. Failure to take this
precaution could result in tipping of the range and cause injury.
3. To Remove a Side Panel
Turn off the power at the circuit breaker.
Pull the range forward.
Pull off the push fi t control panel end caps at
each end and remove the end fi xing screws
under the end cap.
Remove the retaining screws for each panel
(1 at the front and 2 at the rear). The lower
front retaining screws (one each side) are
situated beneath the lower edge at the front
corners of the side panels
Reassemble in reverse order.
To Next Page
Loading...
Need help?
General
