26
Using your Range
Models with window doors
The oven door is triple glazed but the oven door
front panel can be taken off so that the inside
faces of the glass panels can be cleaned.
If necessary move the range forward to gain
access to the sides of the doors (see the
‘Moving the range’ section of these instructions).
The door front panel is held by two fi xing screws
on each side.
The fi xing screws have a recessed hexagon
socket in the head. A hexagon key to fi t the
screw is supplied in the instruction pack.
Open the oven door slightly and use the key to
remove the front panel fi xing screws from the
door sides (two each side).
Carefully lift off the outer door panel. The inside
face of the glass panels can now be cleaned
- take care not to disturb or wet the door
insulation. Please note that the door is triple
glazed but the inner two panels are fi xed. Do not
try to remove the glass from the door.
After cleaning carefully refi t the outer door panel
and replace the side fi xing screws.
Ovens
Some of the oven lining panels can be removed
for cleaning and for cleaning behind. They can
also be put into a dishwasher. Remove the
racks fi rst.
The right hand fanned oven has a removable
oven roof - slide the roof liner forward and
remove.
The side panels of either oven can be removed.
Each side of the oven is fi xed with four fi xing
screws.
You don’t have to remove the screws to remove
the oven linings. Lift each side panel upwards
and they will slide off the screws. Then pull them
forwards
Once the linings are removed, the oven enamel
interior can be cleaned.
When replacing the linings fi t the side linings
fi rst.
To Next Page
Loading...
Need help?
General
